![]() ![]() Host Gateway Last Use Total Uses Interface We expect to see the virtual interfaces with connected networks: Look at the routing table on the Layer 3 switch. ![]() %SYS-5-CONFIG_I: Configured from console by console ![]() %LINEPROTO-5-UPDOWN: Line protocol on Interface Vlan3, changed state to up %LINK-5-CHANGED: Interface Vlan3, changed state to up %LINEPROTO-5-UPDOWN: Line protocol on Interface Vlan2, changed state to up %LINK-5-CHANGED: Interface Vlan2, changed state to up Pings to hosts in the same VLAN will succeed however, pings to hosts from different VLAN will fail (no inter-vlan communication).Ĭreate the virtual interfaces on the Layer 3 switch which will act as the Default Gateway: Let’s check the VLAN port assignments, just like a Layer 2 switch:Īssign IP addresses to our hosts and set the Default Gateway as per the topology. Switch(config-if-range)#switchport access vlan 3 Switch(config-if-range)#switchport access vl Switch(config-if-range)#int range fa0/4 – 5 Switch(config-if-range)#switchport access vlan 2 ![]() Switch(config-if-range)#switchport access vlan Switch(config-if-range)#switchport mode access Switch(config-if-range)#switchport mode acc We start by creating the VLAN’s and assign ports to them, just like a L2 switch.Įnter configuration commands, one per line. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |